ANSWERING SYSTEM OPERATION
FROM A REMOTE TOUCH TONE PHONE
Ending the Remote Access Call
Press *9. The system announces,“The machine will now hang up,” and disconnects from the line.
Changing Remote Access Code
1Connect with the answering system.
2Press 99. The system announces “Enter new code.”
3Enter your new Remote Access Code (any number between 000 and 999).
4If a valid code is entered, the system announces the new Remote Access Code.
If an invalid code is entered, the system beeps five times rapidly, then beeps twice. Repeat Steps 2 and 3.
Turn System Off
1Connect with the answering system.
2Press 00. The system announces,“The machine is off.”
Turn System On
When the system is off, it answers after 10 rings, announces “The machine is off,” and beeps twice.
1Connect with the answering system.
2Press 0to turn the system on. The system announces,“The machine is on.”
3The system beeps twice and is ready to answer calls and record messages. If the system beeps five times, the memory is full.
Memory Full
The system answers after 10 rings, announces “Memory is full,” and beeps twice.
1Connect with the answering system.
2Enter your Remote Access Code after the
3Listen to messages and delete some or all of them.
4Press 0to make sure your system is on before you hang up.
20
