Table/Desk Installation, Connect the power cord | AT&T 9452 specs

Power cord

INSTALLATION

Table/Desk Installation

1 Connect the power cord.

Use only the power cord supplied with this product. If you need a replacement, call 1 800 222-3111.

2Charge the handset battery.

Place the handset in the base. Charge the battery for at least 16 hours the first time. After the first charge, the battery is typically fully charged overnight.

3Connect the telephone line cord(s).

If you have a two- line jack, use only the 4-wire(RJ-14) line cord. Connect the line cord from the wall jack to the jack labeled L1/L1+L2 on the base. Make sure the plugs snap firmly into place.

Standard Modular

electrical telephone

outletjack

L1/L1+L2 jack Power cord

If you have two separate

jacks, use both long line cords. Connect a line cord from the wall jack you wish to designate as your Line 1 to the jack labeled L1/L1+L2 on the back of the base.

Connect the other line cord from the remaining wall jack to the jack labeled L2 on the back of the base. Make sure the plugs snap firmly into place.

Standard
electrical
outlet	L2 jack
	L2 jack

L1/L1+L2 jack

Modular telephone jacks

6

Image 8

AT&T 9452 Table/Desk Installation, Connect the power cord, Charge the handset battery, Connect the telephone line cords

Contents

Part 1 Important Product Information Advanced American Telephones. All rights reserved Contents Page About the Spare Battery Charger Before YOU BeginAbout Caller ID with Call Waiting About the Data Port Installation Before You Install Install the handset battery Select base ringer volume for each line Table/Desk Installation Connect the power cordCharge the handset battery Connect the telephone line cords Wall Installation Connect the power cord to the phoneCheck for dial tone Position the wall mount adapter on the base Mount the base on the wall Telephone Features Feature SetupTelephone Feature Setup Telephone Operation Temporary Tone Dialing Conference CallsThree-Way Conference Calls Four-Way Conference Calls Headset Jack Switching from Handset to Base SpeakerphoneCall Timer Operating Range AT the Base Mute Base Ringer Volume Speakerphone VolumeHold Page/Intercom Dial a Number from Call History Caller ID OperationView Call History Display Screen Messages Erase a Call RecordErase All Call Records Change/Replace a Stored Directory Number Telephone DirectoryStore a Directory Name & Number Edit a Directory Name & Number Erase a Directory Name & NumberStore a Call History Record in Directory Dial a Directory Number About Announcements Audible IndicatorsAbout Mailboxes Record Your Announcement Press Uuntil you hear Set outgoing message Answering System Feature Setup Feature Summary Adjust Playback Volume Listen To, Save & Delete MessagesPlay Messages Delete Messages Call Screening/Intercept Record a MemoConnect with the Answering System Voice Menu Remote Access Commands Message Window Display 99 ↔ F Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack Installing a Spare Battery Spare battery compartment cover If the phone doesn’t work at all, check these items first If the handset does not ring when you receive a callCase of Difficulty If you hear noise or interference when using the phone If you hear other calls while using your phoneIf messages are incomplete If you have difficulty hearing messages If CL appears in the Message Window If your outgoing announcement isn’t clear Remote Commands Answering System Press Machine is off press #0again