AT&T BCM50 manual Assign Code to Access IP Trunk Routes

AT&T IP Flexible Reach Service

Nortel BCM50 Release 3.0 SIP Configuration Guide

Under Configuration Æ Telephony Æ Dialing Plan Æ Routing, select the “Destination Codes” tab to assign a destination code for the IP trunks. Configure a destination code “9” or to whatever code you want to access for outside (IP off-net) call that will be presented to the AT&T service for routing. In this case, when “9” is dialed we wish to push the dialed string to the IP trunk for routing. See figure below.

Note: When completing the Technical Questionnaire Section 6.0 Dial Plan Information and the private dial plan is selected (YES), then please refer to Appendix ‘A’: Configuring Destination Code with Wildcard.

Figure 12: Assign Code to Access IP Trunk Routes

© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T Intellectual Property and/or AT&T affiliated companies. All other marks contained herein are the property of their respective owners.

Issue 0.7 Page 20 of 37