16
1.
Press CLOCK
The system will announce the cur- rent clock setting, then announces
"To set the clock, press CLOCK."
2.
Press CLOCK
The system will announce the cur- rent day setting, then announces
"To change the day, press SKIP or REPEAT, to change the hour, press CLOCK."
3. | Press SKIP or |
| REPEAT |
until the system announces the cor- rect day, then press CLOCK.
4. | Press SKIP or |
| REPEAT |
until the system announces the cor- rect hour, then press CLOCK.
5. | Press SKIP or |
| REPEAT |
until the system announces the cor- rect minutes, then press CLOCK.
6. | Press SKIP or |
| REPEAT |
until the system announces the cor- rect year, then press CLOCK. The system announces the current clock setting.
Answering System Operation
Day and time announcements
To set day and time
Before playing each message, the answering system announces the day and time the message was received.
Before using the answering system, you should follow the steps at left to set the day and time, so messages are dated correctly. If the clock is not set, before playing messages, the system will prompt "Time and date not set" each time.
The system uses voice prompts to guide you. Each time you press 
SKIP or
REPEAT , the day, hour, minute or year increases or decreases by one.When you hear the correct setting, press CLOCK to move to the next setting.
To check day and time
You can press CLOCK at any time to hear the current day and time without changing it.
NOTES:
1.You can press and hold 
SKIP or 
REPEAT to increase or decrease the minute or year by ten.
2.Caller ID provides the time and date. Set the year so that the day of the week can be calculated from the Caller ID information. After you set the time once, it will thereafter be set automatically with incoming Caller ID information. The time will be set automatically only if you subscribe to Caller ID service provided by your local telephone company (see page 5).
37
