AT&T EL52350, EL52510, EL52500 Wall mount installation, Tabletop to wall mount installation

Getting started

Wall mount installation

The telephone base comes ready for tabletop use. If you want to mount your telephone on a wall, use the provided wall mount bracket to connect with a standard dual-stud telephone wall mounting plate. If you do not have this mounting plate, you can purchase one from many hardware or consumer electronics retailers. Professional assistance may be required to install the mounting plate.

Tabletop to wall mount installation

To change the telephone base from the tabletop installation to wall mount installation, make sure you first unplug the power adapter from the electrical outlet and unplug the telephone line cord from the telephone wall jack.

1.Plug one end of the telephone line cord into the TEL. LINE jack on the bottom of the telephone base. Plug the small end of the larger power adapter into the power jack on the bottom of the telephone base.

2.Position the telephone base as shown below. Insert the extended tabs of the wall mount bracket into the slots on the back of the telephone base. Push the telephone base down until it clicks securely in place.

3.Route the telephone line cord through the wall mount bracket hole. Route the power cord out of the bottom of the telephone.

Slots for wall mount bracket installation

DSL filter (not included) is required if you have DSL high- speed Internet service.