ATEN Technology CS-228 user manual Setting Function, SET Password

Setting	Function
SET PASSWORD	This function is used to set passwords for the Administrator and User:
	1. One Administrator and two User passwords can be set.
	2. Move the highlight bar to User or Administrator, then press [Enter].
	A screen that allows you to key in the password appears. The
	password may be up to 8 characters long, and can consist of any
	combination of letters and numbers (A - Z, a - z, 0 - 9).
	3. For a new password, key in the new password. To modify or delete
	a previous password, use the backspace key to erase individual
	letters or numbers, then key in the new password.
	4. Press [Enter]. You are asked to key the password in again, in
	order to confirm that it is correct.
	5. Key in the new password again, then press [Enter].
	If the two entries match, the new password is accepted. If the
	entries do not match, you must start again from the beginning.
	6. If the Administrator wants to change a User’s password, he must
	enter his Administrator’s password first.
SET ACCESSIBLE	This function allows Administrators to select which Ports can be
PORTS	accessed from a particular Console. Move the highlight bar to the
	target computer, then press [Enter] or the [Spacebar] to toggle
	access On and Off. If access is On, a plus mark ( + ) appears to
	indicate so. If access is Off, the area is blank. Make your choice,
	then press [Esc] to confirm.
SET MULTIUSER MODE	This function determines whether or not the same ID can be used to
	log into the CS-228 from the second Console at the same time that
	it is being used at the first one.
	1. If Disabled, the same ID cannot be used; if Enabled (the default),
	the same ID can be used to log in from the second Console.
	2. If Enabled, the F4, F6, and F7 settings set for any one Console,
	will be the same for all other Consoles that log in with the same ID.
	3. Changes made to the F4, F6, and F7 settings by any logged in
	Console will automatically affect all Consoles with the same ID.
SET ACCESS TIMEOUT	This function is used to set the timeout value to control the release of
	access rights to a computer. If the original Console doesn’t access
	the computer before the timeout value is reached, the computer
	becomes available to the other Console. To set the timeout value,
	key in a number from 2 - 255 seconds, then press [Enter] (if the
	number is 0 (zero), this function is disabled. Default is 10 seconds.
CLEAR THE NAME LIST	This function is used to undo all Administrator changes and return
	the setup to the original factory default settings.
	Note: While this function is in progress, make sure that no other
	operations are performed on the other Console.
RESTORE DEFAULT	This function is used to undo all Administrator changes and return
VALUES	the setup to the original factory default settings - except for the
	Names that were assigned to Ports, which are saved.

CS-228 User Manual 15

2001-02-01