Chapter 2
Hardware Setup
Installation
1.Important safety information regarding the placement of this device is provided on page iv. Please review it before proceeding.
2.Make sure that power to all the devices you will be connecting up have been turned off. You must unplug the power cords of any computers that have the Keyboard Power On function.
Single Stage Installation
In a Single Stage installation, there are no additional KH98's cascaded down from the first unit. To set up a single stage installation refer to the diagram below (the numbers in the diagram correspond with the numbers of the instruction steps), and do the following:
1.Plug your keyboard, mouse, and monitor into the unit's Console Ports.
2.Use KVM cable sets (as described in the Cables section on page 3), to connect any available KH98 KVM Port to the Keyboard, Video and Mouse ports of the computer you are installing.
3.Plug the Cat 5 cable that connects the KH98 to the IPMI Management LAN. (This step is optional, see note below).
Note: This step is only applicable to IPMI installations. Only the first KH98 unit should be connected to the IPMI Management LAN. See picture below.
4.Plug the power cord that came with this package into the KH98's Power Socket, and then into an AC power source.
5.Power on the monitor.
6.Power on the KH98.
9