KVM Over the NET™ User Manual
6.On the RADIUS server, Users can be authenticated with any of the following methods:
Set the entry for the user as su/xxxx
Where xxxx represents the Username given to the user when the account was created on the KN1108v / KN1116v switch.
Use the same Username on both the RADIUS server and the KN1108v / KN1116v switch.
Use the same Group name on both the RADIUS server and the KN1108v / KN1116v switch.
Use the same Username/Group name on both the RADIUS server and the KN1108v / KN1116v switch.
In each case, the user’s access rights are the ones assigned that were assigned when the User of Group was created on the KN1108v / KN1116v switch. (See Adding Users, page 129.)
LDAP / LDAPS Authentication and Authorization Settings
To allow authentication and authorization for the KN1108v / KN1116v switch via LDAP / LDAPS, refer to the information in the table, below:
Item | Action |
|
|
Enable | Put a check in the Enable checkbox to allow LDAP / LDAPS |
| authentication and authorization. |
|
|
Type | Click a radio button to specify whether to use LDAP or LDAPS. |
|
|
LDAP Server IP | Fill in the IP address and port number for the LDAP or LDAPS |
and Port | server. |
| You can use the IPv4 address, the IPv6 address or the |
| domain name in the LDAP Server field. |
| For LDAP, the default port number is 389; for LDAPS, the |
| default port number is 636. |
|
|
Admin DN | Consult the LDAP / LDAPS administrator to ascertain the |
| appropriate entry for this field. For example, the entry might |
| look like this: |
| ou=kn4132,dc=aten,dc=com |
|
|
Admin Name | Key in the LDAP administrator’s username. |
|
|
Password | Key in the LDAP administrator’s password. |
|
|
Search DN | Set the distinguished name of the search base. This is the |
| domain name where the search starts for user names. |
|
|
Timeout | Set the time in seconds that the KN1108v / KN1116v switch |
| waits for an LDAP or LDAPS server reply before it times out. |
|
|
157