AVR2070
67
8240B-AVR-06/09
5. Load J-Link .dll for debugging
a. Target -> Connect Segger J-Link
b. Should see “DLL WARNING”
c. Select Tools -> Targets
d. Highlight “Segger J-Link”, right-click and select “Properties” as shown
in figure D-3-1.
e. Find Properties window in lower right corner, make sure properties of
“Segger J-Link” is selected.
f. Highlight “J-Link DLL File”
g. Locate .dll file from Segger folder (ie. C:/Program
Files/SEGGER/JLinkARM_V392/JLinkARM.dll)
h. Re-do Step A.
i. Verify Device Type Connects to J-Link
Figure D-2-1 Segger J-Link DLL Installation
6. To Start debugging
a. Debug -> Start Debugging
D.2.1 Rowley RUM Project
The Rowley project file can be launched by opening up the \patch folder and
navigating to the \Rowley RUM Project File folder containing the .hzp project file. This
file needs to be copied over the original Rowley project file located in the
\uTaskerV1.3\Rowley_SAM7X\ folder. Assuming all the project patch procedures and