| AT Commands | 57 | |
| AT command formats | ||
|
|
|
|
Connection Time (sec) | 19.968 |
|
|
OK |
|
|
|
The ATI11 command may be issued from online command mode or after the end of a call. After a call, some of the values are no longer valid. The following table defines each command result, and indicates if the result is valid only during the call:
Description | Definition |
Last Connection | V.92, V.90, V.34, or V.32, |
| depending on the type of connection |
| negotiated. |
Initial Transmit | Initial upstream rate. |
Carrier Rate |
|
Initial Receive | Initial downstream rate. |
Carrier Rate |
|
Final Transmit | Current or final upstream rate. |
Carrier Rate |
|
Final Receive | Current or final downstream rate. |
Carrier rate |
|
Protocol | LAPM, MNP, or NONE, depending |
Negotiation | on V.42 negotiation. |
Result |
|
Data Compression | V.44, V.42bis, MNP5 or NONE. |
Result |
|
Estimated Signal/ | |
Noise Level | negative. Higher values indicate |
| better conditions. |
Receive Signal | The received signal power which, |
Power Level | although labeled in |
relative measure for comparing | |
| calls to and from different locations. |
| This value is valid only during a |
| call. |