ATO V.9256K +PCW Command, +PCW=<call waiting, +PCW, +PCW

AT Commands	77
AT command formats

+PCW Command

This command configures how the modem responds to a call waiting signal. The modem’s response is also determined by the current configuration of the +VCID caller ID command (See “+VCID Command” on page 79 for information on this command). You can also use the +PCW command to display the current call waiting configuration, and to display the supported <call waiting> parameter values.

+PCW=<call waiting>

Valid <call waiting> parameter values are as follows:

0Enables the call waiting detector. When a call waiting signal is detected, the modem responds to it according to the +VCID caller ID command configuration. This is the default.

1Enables the call waiting detector. When a call waiting signal is detected, the modem hangs up the current call and answers the waiting call.

2Disables the call waiting detector.

Result Codes:

OK <call_waiting> = 0,1,2

ERROR Otherwise

+PCW?

This command displays the current call waiting configuration.

+PCW=?

This command displays the supported <call_waiting> parameter values.