A T O N | AH66T INSTALLATION MANUAL |
|
|
Stereo Zone w/ Stereo
Connect the Zone Preamp Output of the AH66T to the Audio Inputs of the ATON A275 amplifier. Using the ATON configuration software, configure the Zone Preamp Output to FIXED. Connect the amplified output from the A275 to the Amplifier Input of the DLA Speaker Selector. The main zone ramps the AH66T’s internal amplifier volume up/down at preamp level using IR or
The Speaker Selector can be controlled using its front panel buttons, IR commands from handheld remotes or by using DLATP touchpads connected to the Speaker Selector. An optional ATON RF remote is also available.
The diagram on the next page shows an OLED2 controlling zone one of the AH66T. Commands from the OLED2 control the AH66T’s internal amplifier. Zone one’s preamp output is set to FIXED and sends audio signals to the ATON A275 amplifier which then sends its amplified output to the DLA4 Speaker Selector.
The DLA4 allows independent volume control for each speaker or speaker pair connected to the Room outputs. In this example, Areas A and D are using
(Please visit www.atonhome.com for more information on the DLA Speaker Selector series of products and the A275 amplifier.)
© ATON 2010 All rights reserved. | Page 15 |