ATON AH66T-KT Appendix B: Rack Mounting, RMK3 Rack-MountKit, Figure B-1, Figure B-2, Figure B-3

A T O N AH66T INSTALLATION MANUAL

Appendix B: Rack Mounting

RMK3 Rack-Mount Kit

When mounting the AH66T controller in an equipment rack, use the ELAN RMK3 Rack Mount Kit for secure mounting and proper ventilation. The RMK3 requires three rack spaces. To install the RMK3 into a standard 19” equipment rack:

1. Slide the rack mount kit onto the AH66T chassis from the front as shown in Figure B-1.

Figure B-1

2.Ensure that the unit is flush with the front of the mounting kit. Install each of the eight screws (included) through the side mounting flanges into the holes in the sides of the unit as shown in Figure B-2. Hand tighten screws! Over-tightening could cause damage to the AH66T Controller.

Figure B-2

3.Once the unit is securely mounted into the RMK3, install the entire assembly into a standard 19” equipment rack from the front using four rack screws (not included).

Figure B-3

© ATON 2010 All rights reserved. Page 84