Aussie Kanga, Bonza Deluxe owner manual Manual Lighting of the Grill

Manual Lighting of the Grill

4)Locate the control knob that corresponds to the match lighting hole that you are using. Push in and turn the control knob counter-clockwise until a click is heard.

·Open Lid or Hood (depending on the model) before lighting the grill to prevent an explosion from gas build-up.

·The Lid (Kanga™ series only) must never be covering the cooking surface while the LP gas grill is in use or hot.

·Always inspect the gas hose and regulator assembly

before each use. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill.

Contact the manufacturer, as the hose must be replaced with an assembly specified by the manufacturer prior to further use of the LP gas grill.

How to manually light your LP gas grill

1)Open Lid or Hood (depending on the model)

2)Important: The LP gas cylinder valve must be opened first before turning the control knobs on the grill. Turn the handle on the LP cylinder valve counter- clockwise until it stops.

3)Insert a lit match through one of the match-lighting holes underneath the front control panel on the grill. (See figure below).

WARNING: If the burner fails to ignite after following the above procedure, turn all the knobs to the off position and close the valve on the LP cylinder. Wait five minutes and repeat all of the above manual lighting procedures. If the grill still fails to light, see the Troubleshooting page.

5)Light the remaining burners from left to right by turning the control knob counter-clockwise. Your grill has a crossover ignition system that allows the burners to light successively off one another. Confirm each burner is lit before

lighting another burner.

6)After ignition, burners should be burned at the high position for 3-5 minutes in order to preheat the grill. This process should be done before every cooking session. The hood (Bonza™ series only) should be closed during preheating. The lid (Kanga™ series only) must never be covering the cooking surface while the grill is in use or hot.

WARNING: If a burner goes out during the cooking cycle, turn all knobs to the off position and close the valve on the LP cylinder. Open hood (BonzaTM series only) and wait five minutes before attempting to relight the grill.

1. Open lid or hood (depending on model)

2. Turn LP cylinder han- dle counter-clockwise -

3.Match lighting hole in left side of grill body - Insert a lit match through the match lighting hole.

4.Push in and turn control

knob counter-clockwise to the “High” position. (Note a click may be heard)

29