Aussie Bonza Leak Testing To Be Performed In A Well-Ventilated Area, How to perform a leak test

Models: Kanga Bonza Deluxe

1 36
Download 36 pages 4.35 Kb
Page 24
Image 24
STEP 15-LEAK TESTING (TO BE PERFORMED IN A WELL-VENTILATED AREA.)

STEP 15-LEAK TESTING (TO BE PERFORMED IN A WELL-VENTILATED AREA.)

·Perform a leak test before each use.

·Leak test must be performed in a well ventilated area.

·Never perform a leak test on a grill while in use or hot.

·If you detect a gas leak that cannot be corrected by using the leak test procedures below, do not use the LP gas grill.

·Never smoke or have an open flame near the grill during a leak test.

·Insure Regulator Hose does not contact hot metal surfaces.

Supplies Needed for a Leak Test

Clean paint brush, water, and dishwashing liquid

How to perform a leak test

WARNING! Never use an open flame to test for gas leaks.

1)Mix one cup of water with one cup of dish washing liquid.

2)Confirm that all control knobs on the control panel are in the off position.

3)Remove control knobs and the three retaining screws at the bottom of the control panel.

4)Remove front control panel cover.

5)Open valve on LP gas cylinder (Turn counter- clockwise).

6)Check for leaks by brushing the soap solution on all LP gas connections and fittings. Make sure you generously brush the seven locations with the soap solution, completely surrounding the connections and fittings (See diagram below.)

7)If “growing” bubbles appear on any of the connection points, then you have detected a gas leak. Immediately close the LP cylinder valve.

A)If leak appears at either end of hose and regulator assembly, retighten the connection at the leak, but do not overtighten. (Note: Only hand tighten at coupling nut) (See Step 10 of Assembly Instructions) Repeat Leak Test.

B)If the leak is coming from the LP gas cylinder, from the valves at the control knobs, or if the leak cannot be stopped, do not use the grill. Call Customer Service at 1-800-251-7558.

8)Always turn off LP cylinder valve after performing a leak test. (Turn clockwise to a full stop.)

9)If your LP gas grill has been in storage or has not been used for a period of time, the burners should be maintained. See Burner Maintenance in the Care and Maintenance section of this manual.

2

1

1-MANIFOLD TUBE

2-REGULATOR HOSE FITTING

5, 6, 7 -GASKET SEAL AROUND MANIFOLD TUBE

5

6

7

3

3-THREADED FITTING

4-HOSE CONNECTION

4

24

Page 24
Image 24
Aussie Bonza Deluxe Leak Testing To Be Performed In A Well-Ventilated Area, · Perform a leak test before each use