Aussie Bonza Burners will not light, Using the ignitor, Using a match, Low flame or low heat

TROUBLESHOOTING

Problem	Possible Cause	Solution
Burners will not light	Burners not assembled cor-	See Step 9 - Install Burners of the Assembly Instructions
using the ignitor	rectly

Not pausing long enough before clicking the control panel knob

No spark

LP gas cylinder is empty

Coupling nut is not fully con- nected to regulator

Excess flow valve tripped in regulator

Obstructions in burners

Electrodes and burners are wet

Wire is loose or disconnected

Wire is shorting (sparking between ignitor and elec- trode)

When lighting the 1st (Leftmost) Burner, push-in and turn con- trol panel knob counter-clockwise until you feel resistance with turning. Pause 4 seconds with knob still pushed in, then contin- ue turning knob counter-clockwise until a click is heard

Gas collector tab is bent (making too large or small of a gap between electrode and tab). By hand, bend gas collector tab back within a maximum of 3/16” gap to electrode. (See page 19 for illustration).

Take LP gas cylinder to licensed LP gas supplier to be refilled

Tighten coupling nut by hand about one-half to three quarters additional turn. Do not use tools.

Turn control knobs to “off” position and turn LP gas cylinder handle clockwise until it stops. Wait five minutes. Relight LP gas grill.

Clean burners (See Burner Maintenance in Care and Maintenance section of this manual)

Dry electrode with clean cloth

Reconnect the wire

Replace ignitor wire/electrode assembly (Call the Customer Service Department)

Burners will not light	Burners not assembled cor-	See Step 9 - Install Burners page of the Assembly Instructions
using a match	rectly
	LP gas cylinder is empty	Take LP gas cylinder to licensed LP gas supplier to be refilled
	Excess flow valve tripped in	Turn control knobs to “off” position and turn LP gas cylinder
	regulator	handle clockwise until it stops. Wait five minutes. Relight LP
		gas grill.
	Coupling nut is not fully con-	Tighten coupling nut by hand about one-half to three quarters
	nected to regulator
	Obstructions in burners	Clean burners (See Burner Maintenance in Care and
		Maintenance section of this manual)
Low flame or low heat	Gas in LP cylinder is low	Check LP gas cylinder. Refill if necessary.
	Excess flow valve tripped in	Turn control knobs to “off” position and turn LP gas cylinder
	regulator	handle clockwise until it stops. Wait five minutes. Relight LP
		gas grill. If flame remains to be low, turn off gas at cylinder and
		grill. Disconnect the regulator from the LP gas cylinder.
		Reconnect the regulator to the LP gas cylinder. Perform a leak
		test. Relight grill. This will reset the excess flow valve.

33