24 Operation
Travis Industries 412 210 4 93508117

Optional Blower - Adjusting the Speed

The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to
temperature (approximately 10 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.

OFF

Turn the dial all the
way counter-clockwise
until it clicks off.

HIGH

The high position is all the
way counter-clockwise,
without clicking off.

LOW

Turn the dial all the
way clockwise.

Normal Operating Sounds

Gas Control Valve
As the gas control valve is turned
on and off you will hear a dull
clicking sound. This is the valve
opening up and shutting down.
Blower Snap Disk
This part can produce a clicking sound
as it turns the blower on and off.
The appliance may creak with
change of temperature.
Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Optional Blower
This heater may utilize a blower to push
heated air into the room. You will hear
the sound of air movement that
increases as the speed is increased.
Extinction Pops
It is not unusual, especially on Propane (LP) appliances,
to experience a "pop" when the burner is shut off.

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas may
burn and create a burnt-paper smell. This is normal during startup. You may notice the smell is more acute
if the appliance was left idle for a long period.