Optional Equipment | 35 |
Blower (part # 99000153)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to conducting service.
1.Attach the two black wires at the rear right of the stove to the thermodisk (orientation does not matter). Then slide the thermodisk into the holder underneath the burner pan.
of Back Stove
Snap Disk Bracket 
(attached to stove)
Snap Disk
Snap Disk Wires on Wiring Harness (Black - orientation does not matter)
2.Place the blower near the rear of the stove. Attach the wiring in grommets following the directions below.
of Back Stove
f
Route the wires labeled “Valve on/off” and “Solenoid” under the burner pan to a location
near the gas control valve. e Attach the two wires leading
from the control box to the two block wires labeled “Rheostat”.
Remove one of the screws holding
a
the mounting bracket in place. Insert the screw through the eyelet on the green ground wire and replace.
1/4" Nutdriver
b Attach the black and white wires labeled “Blower” to the blower
(orientation does not matter).
c Attach the molex connector.
d Slide the rubber grommets (with | DO NOT PLUG THE STOVE | |
IN UNTIL INSTALLATION IS | ||
spacers inserted inside) onto the | ||
| ||
fan mounting bracket. | COMPLETE. | |
|
Travis Industries | 4 1 2 2 1 0 4 | 9 3 5 0 8 1 1 7 |
