![](/images/new-backgrounds/1054851/5485175x1.webp)
36Optional Equipment
3Slide the left side of the blower mounting bracket over the grommets on the left mounting bracket attached to the stove (see the illustration below). Then insert the stud plate through the right side grommets and through the right mounting bracket on the stove. Secure the stud plate with the included washers and nuts
| Make sure the bracket |
Left Mounting | slides into the groove on |
| |
Bracket (on stove) | the rubber grommets. |
|
Right Mounting
Bracket (on stove)
Stud Plate
of Back Stove
Blower Mounting
Bracket
Rubber
Grommet
Blower Mounting Bracket
Stud Plate
Blower Mounting Bracket
11/32” | Washer |
Socket | |
| Nut |
4Make sure all of the wiring is placed away from the blower impeller and the bottom of the burner. Use lock ties, if necessary, to ensure no wires are damaged.
5Open the control cover following the directions below. Remove the button plug and install the rheostat.
Loosen the two screws holding the control |
| Attach the rheostat wires to the two |
a box in place. This allows access to the | c | quick connects inside the control |
back of the control box. |
| box (orientation does not matter). |
Control Box |
|
|
Phillips |
|
|
Screwdriver |
| Rheostat |
Back of
Stove
Attach the knob.
b | Remove the button plug |
from the control box. |
NOTE: make sure the fiberglass heat shield is in place when
e
Attach the rheostat to the control panel with the included nut and star washer.
1/2"
Wrench
NOTE: this tab fits into the hole on the mounting bracket.
6Plug the blower in. Let the heater achieve operating temperature and test blower operation.
Travis Industries | 4 1 2 2 1 0 4 | 9 3 5 0 8 1 1 7 |