![](/images/new-backgrounds/1054851/5485171x1.webp)
34Optional Equipment
8Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leak- test all gas connections and the gas control valve. Check the pilot. Adjust if necessary.
WARNING: When lighting or
To adjust the pilot flame, turn this screw (NOTE: if totally |
| The pilot flame must contact the thermocouple and |
unscrewed gas will come out of this port). Clockwise |
| thermopile (see the illustration below). Adjust the pilot up or |
lowers the flame while | Standard | down as necessary. |
| Screwdriver |
|
Fireback (part # 98500747)
Follow the directions below. Remove the log set prior to installation.
| Remove this screws on the roof of the firebox |
b | (the forward screw on the outside). Place the |
side fireback in place and secure with a clip and | |
| screw as shown. Repeat for the opposite side. |
1/4" Nutdriver
a
Remove the two screws on the back wall of the firebox. Use the two screws to secure the rear fireback clip. Place the rear fireback on top of the clip (the side firebacks keep the rear fireback from falling forward).
1/4" Nutdriver
Travis Industries | 4 1 2 2 1 0 4 | 9 3 5 0 8 1 1 7 |