Installation (for qualified installers only) | 15 |
Vent Location
•A vent restrictor is built into the appliance to adjust the flow rate of exhaust gases. This ensures proper combustion for all vent configurations. Depending upon the vent configuration, you may be required to adjust the restrictor position. The charts for acceptable vent configurations detail the correct vent restrictor position.
| Center Line |
Exhaust (4” Dia.) | Inlet (3” Dia.) |
NOTE: Vent location changes based |
|
|
|
|
|
|
|
upon restrictor position. Position # 1 is |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
shown to the right. Each restrictor |
|
|
|
|
|
|
|
position moves the vent location forward |
|
|
|
|
| 2” | |
|
| ||||||
|
|
|
|
|
|
|
(toward the fireplace opening) approximately 1/4”.
Fireplace
Opening
Vent Configurations
Inlet & Exhaust | Exhaust Only |
Direct Vent Cap
(part # 991)
Exhaust |
|
4" dia. | |
Gas Liner | Adapter & Flashing |
| (Travis Part # 98900124) |
| Inlet |
| 3" dia. Gas Liner |
Recommended
Exhaust
4" dia. Gas Liner
Any cracks or damage inside the chimney must be repaired.
A
Inlet
Z.C. (Metal) | Masonry Fireplace |
NOTE: You may use either
© Travis Industries | 4080123 |