36 | Optional Equipment (for qualified installers only) |
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1Remove the glass (see page 20). Remove the logs and coals (if installed - page 22)
2Remove the burner (see illustration below).
WARNING: Do not disassemble the burner – screws on the burner must be left in place.
| b | Lift the pilot hood off the pilot | |
a | assembly (you may need to | ||
| |||
| pull hard to remove). | ||
|
|
Remove the firebox floor.
c
WARNING:
The burner is fragile - handle it with care.
Lift the left side of the burner slightly, then slide it to the left and lift it upwards (lift the burner from below).
d
Pull the burner forward, out of the firebox.
Burner Replacement:
Make sure the bolt head on
Make sure the burner is fully seated.
the bottom of the burner
Replace the pilot hood after replacing the burner.
When in place, the pilot flame must align
directly above the burner holes.
inserts into this hole.
Slide the air shutters all the way to the right before installing the burner.
Make sure the mixing tubes slide onto the orifices.
Mixing Tubes
NOTE:
Make sure the burner is fully seated. When in place, the pilot flame must align directly above the burner holes.
Orifices
© Travis Industries | 4080123 |
