38 | Optional Equipment (for qualified installers only) |
5Install the logs and embers.
6Replace glass and face.
7Remove the regulator from the front of the gas control valve. Replace with the propane regulator, using the new gasket and screws included with the regulator. NOTE:
Leak test this area after the heater is installed, gas is connected, and the main burner is lit.
a
Remove and discard the three screws using a slotted screwdriver of Torx
Slotted
Screwdriver
(or
c
Install the LP regulator. Use the screws included with the LP regulator. Tighten to approximately 25 Lbs. torque.
Slotted
Screwdriver
(or
b
Remove and discard the regulator, diaphram, spring and center post.
NOTE: Make sure the regulator gasket is correctly aligned before installation.
d
Place the LP label on the base near the gas control valve.
8Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly
WARNING: | When lighting or | |||||||||||
To adjust the pilot flame, turn this screw (NOTE: if totally |
|
| The pilot flame must contact the thermocouple and | |||||||||
unscrewed gas will come out of this port). Clockwise |
|
| thermopile (see the illustration below). Adjust the pilot up or | |||||||||
lowers the flame while | Standard | down as necessary. | ||||||||||
|
|
|
|
| Screwdriver |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
© Travis Industries | 4080123 |