Manuals / Avaya / Personal Care / Mobility Scooter

Avaya A2400 CLI command configuration, CLI Commands, Required Settings, Default, Description

Models: AP61

1 20

Page 11

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

CLI Commands	Required Settings	Default	Description
CLI Commands	Required Settings	Settings	Description
		Settings

Short preamble	Tested: Enable	Enable	Set the short preamble to
	Recommended: Disable		disable, to enable long-
			preamble-only support.

CLI command configuration

All of the commands listed in the CLI Commands column above must be entered under the ap

location command.

The format is:

ap location x.y.z

phy-type g (To make the changes for the “g” radio.) commands

phy-type a (To make the changes for the “a” radio.)

commands

Page 11

Image 11

Avaya A2400 CLI command configuration, CLI Commands, Required Settings, Default, Description, ap location x.y.z, commands

Contents

Aruba Mobility Controller Configuration and Deployment Guide Service InformationConfiguration Guide Certified Product SummaryDeployment Description Interface settingDefault route Network TopologyTyped command Connecting to the Mobility ControllerConnecting the APs Command, comment, and screen text keyssh admin@switch IP address Via the CLIVia the Web interface Welcome to Aruba Wireless Networks - Aruba Initial SetupAruba config-subif#ip address 10.168.10.2 Connecting APsAssigning an IP to the Mobility Controller Provisioning APsconfigure terminal ap location x.y.z SSID ConfigurationCLI command configuration Web-based configuration10. Enter the PSK AES Key/Passphrase Access Point ConfigurationRadio setting 802.11b or 802.11g Preamble settingsRequired Settings Channel and Tx powerRecommended AP configuration settings CLI CommandsSettings CLI CommandsRequired Settings DefaultDefault CLI command configurationCLI Commands Required Settingsa. For ARM Assignment, select Disabled Web-based configurationa. For ARM Assignment, select Disabled arm assignment single-band arm voip-aware-scan enable write mem Security Policies and Quality of Service QoSDynamic RF Management - ARM Aware Scanning configure terminal ap location x.y.z phy-type g arm scanning enableCreate an alias for the AVPP Create policies for the wireless IP telephone usernetdestination avpp host 10.168.0.11 host Assign policies to the roleconfigure terminal netdestination tftp-server host ip access-list session phoneacl user user any denyAruba# configuration terminal Aruba config# firewall voip-proxy-arp AuthenticationQuality of Service QoS Subnet Roamingip route 224.0.0.0 255.0.0.0 ipaddr of NetLink Gateway exit write mem CLI commands to set up subnet roamingCommands for the master switch the Aruba Configure terminal ip default-gateway ipaddr of routerConfigure terminal Commands to verify setup for sub-net routingCommands for the local switch the Aruba From the Arubashow station-table Checking the Configurationshow ap config location x.y.z show stm connectivity