Manuals / Avaya / Personal Care / Mobility Scooter

Avaya A6000, AP60 Access Point Configuration, Radio setting 802.11b or 802.11g, Preamble settings

Models: AP61

1 20

Page 8

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

7.Select the AES-CCMoption for WPA2-AES-PSK encryption.

8.Under WPA2, select the PSK AES-CCMoption.

9.Select PSK Passphrase (alphanumeric) from the Format drop-down list before typing in the passphrase.

10.Enter the PSK AES Key/Passphrase.

11.Click the Apply button.

Navigating to other pages without saving/applying the changes will result in the loss of the changes.

Access Point Configuration

Radio setting 802.11b or 802.11g

When using the 802.11b/g band for the VoWiFi network, set the radio settings to 802.11b/g mixed mode.

Preamble settings

The tests on the Aruba system were run with the short preamble setting.

The short preamble setting can be used, as this supports both short and long preambles. Wireless IP Telephones only support long preamble.

When using a dual-radio AP, use the 802.11a radio for data and 802.11b/g for voice if possible, as this will improve the overall performance.

Page 8

Image 8

Avaya A6000, AP60, AP65, A2400, A200, A800 Access Point Configuration, Radio setting 802.11b or 802.11g, Preamble settings

Contents

Service Information Configuration GuideCertified Product Summary Aruba Mobility Controller Configuration and Deployment GuideInterface setting Default routeNetwork Topology Deployment DescriptionConnecting to the Mobility Controller Connecting the APsCommand, comment, and screen text key Typed commandssh admin@switch IP address Via the CLIVia the Web interface Initial Setup Welcome to Aruba Wireless Networks - ArubaConnecting APs Assigning an IP to the Mobility ControllerProvisioning APs Aruba config-subif#ip address 10.168.10.2SSID Configuration CLI command configurationWeb-based configuration configure terminal ap location x.y.zAccess Point Configuration Radio setting 802.11b or 802.11gPreamble settings 10. Enter the PSK AES Key/PassphraseChannel and Tx power Recommended AP configuration settingsCLI Commands Required SettingsCLI Commands Required SettingsDefault SettingsCLI command configuration CLI CommandsRequired Settings DefaultWeb-based configuration a. For ARM Assignment, select Disableda. For ARM Assignment, select Disabled Security Policies and Quality of Service QoS Dynamic RF Management - ARM Aware Scanningconfigure terminal ap location x.y.z phy-type g arm scanning enable arm assignment single-band arm voip-aware-scan enable write memCreate policies for the wireless IP telephone user Create an alias for the AVPPAssign policies to the role configure terminal netdestination tftp-server hostip access-list session phoneacl user user any deny netdestination avpp host 10.168.0.11 hostAuthentication Quality of Service QoSSubnet Roaming Aruba# configuration terminal Aruba config# firewall voip-proxy-arpCLI commands to set up subnet roaming Commands for the master switch the ArubaConfigure terminal ip default-gateway ipaddr of router ip route 224.0.0.0 255.0.0.0 ipaddr of NetLink Gateway exit write memCommands to verify setup for sub-net routing Commands for the local switch the ArubaFrom the Aruba Configure terminalChecking the Configuration show ap config location x.y.zshow stm connectivity show station-table