Manuals / Avaya / Personal Care / Mobility Scooter

Avaya AP41, AP60, AP65, A2400, A200, A800, AP61, AP70, A6000 Dynamic RF Management - ARM Aware Scanning

Models: AP61

1 20

Download 20 pages 13.78 Kb

Page 14

Aruba Mobility Controller	Configuration Guide
	VIEW Certified

Dynamic RF Management - ARM Aware Scanning

If Adaptive Radio Resource Management (ARM) Aware Scanning (RF scanning) is included in your firmware release, it can be enabled through the command line interface as follows:

configure terminal ap location x.y.z phy-type g

arm scanning enable

arm assignment single-band arm voip-aware-scan enable write mem

This feature was enabled during VIEW Certification testing in a screen room (strong signals in a clean environment). A real-world test with interfering RF signals was not simulated.

Security Policies and Quality of Service (QoS)

Once the basic infrastructure is configured, it is necessary to configure the security policies to ensure that the data network and the voice network are secured and access to these networks is limited as required.

The steps are as follows:

1.Setup aliases for the AVPP.

2.Set policies for the wireless IP telephone User to the required voice server, DHCP and TFTP servers. Add other ACLs as required to permit other traffic from the wireless IP telephones.

3.Assign policies to the role.

Page 14

Image 14

Avaya AP41, AP60, AP65, A2400, A200 Dynamic RF Management - ARM Aware Scanning, Security Policies and Quality of Service QoS

Contents

Certified Product Summary Service InformationConfiguration Guide Aruba Mobility Controller Configuration and Deployment GuideNetwork Topology Interface settingDefault route Deployment DescriptionCommand, comment, and screen text key Connecting to the Mobility ControllerConnecting the APs Typed commandssh admin@switch IP address Via the CLIVia the Web interface Initial Setup Welcome to Aruba Wireless Networks - ArubaProvisioning APs Connecting APsAssigning an IP to the Mobility Controller Aruba config-subif#ip address 10.168.10.2Web-based configuration SSID ConfigurationCLI command configuration configure terminal ap location x.y.zPreamble settings Access Point ConfigurationRadio setting 802.11b or 802.11g 10. Enter the PSK AES Key/PassphraseCLI Commands Channel and Tx powerRecommended AP configuration settings Required SettingsDefault CLI CommandsRequired Settings SettingsRequired Settings CLI command configurationCLI Commands DefaultWeb-based configuration a. For ARM Assignment, select Disableda. For ARM Assignment, select Disabled configure terminal ap location x.y.z phy-type g arm scanning enable Security Policies and Quality of Service QoSDynamic RF Management - ARM Aware Scanning arm assignment single-band arm voip-aware-scan enable write memCreate policies for the wireless IP telephone user Create an alias for the AVPPip access-list session phoneacl user user any deny Assign policies to the roleconfigure terminal netdestination tftp-server host netdestination avpp host 10.168.0.11 hostSubnet Roaming AuthenticationQuality of Service QoS Aruba# configuration terminal Aruba config# firewall voip-proxy-arpConfigure terminal ip default-gateway ipaddr of router CLI commands to set up subnet roamingCommands for the master switch the Aruba ip route 224.0.0.0 255.0.0.0 ipaddr of NetLink Gateway exit write memFrom the Aruba Commands to verify setup for sub-net routingCommands for the local switch the Aruba Configure terminalshow stm connectivity Checking the Configurationshow ap config location x.y.z show station-table