Aruba Mobility Controller | Configuration Guide |
| VIEW Certified |
Commands for the local switch (the Aruba 6000):
The AP's IP address must be on same
Configure terminal
masterip <ip address of the master> interface loopback
ip address <ip_addr of the 6000> vlan 1
interface vlan 1
ip address <ip_addr of the 6000> <netmask> interface fastethernet <port>
switchport access vlan 1 (only if the port is an access port) trusted
no shut
!
ip
!
exit write mem
After the master IP and the switch IP address are configured on the local switch, the switch needs to be rebooted prior to use.
It is also necessary to set the default gateway of the Avaya Voice Priority Processor and NetLink Telephony Gateway to the IP address of the router connected to the master switch.
Commands to verify setup for sub-net routing
From the Aruba 800:
show | master ip | (should be 800’s ip) |
show | stm connectivity | (shows the APs connected to the Aruba |
|
| 800 switch) |
Ping the local switch.
Pings should be successful.
From the Aruba 6000:
show master ip | (should be 800’s ip) | |
show | stm connectivity | (shows the APs connected to the Aruba |
|
| 6000 switch) |
show | running configuration (shows ap & aaa rules are carried from | |
|
| the master to the slave) |
Page 19
