Chapter 5: CCM Appliance Commands | 51 |
|
|
Syntax
SERVER FLASH BOOTAPP HOSTIP=<tftp_add> IMAGE=<host_file>
Table 5.11: Server FLASH Command Parameters
Parameter | Description | |
|
| |
BOOTAPP | Indicates either the boot image should be updated or the application image should | |
be updated. | ||
| ||
|
| |
HOSTIP=<tftp_add> | IP address of TFTP server host. | |
|
| |
IMAGE=<host_file> | Name of file on TFTP server host containing the image file. | |
|
|
Example
The following command updates the boot image program using the image file name c:\winnt\system32\drivers\ccm50bt.img, which is located on the TFTP server host located at 192.168.1.16.
>ser fla app hostip=192.168.1.16 c:\winnt\system32\drivers\ima=ccm50bt.img
Server PPP commandThe Server PPP command enables or disables the PPP server on the console port. For more information and requirements, see Connecting to devices using PPP on page 15 and Configuring and using
Once the PPP server has been configured with this command by specifying the required addresses and masks, those values remain in the database. Later, if you disable the PPP server and wish to reenable it with the same addresses, you don’t need to specify the address values again.
When you enter this command, you are prompted to confirm or cancel the specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER PPP DISABLEENABLE
[LOCALIP=<local_ip>] [REMOTEIP=<rem_ip>] [MASK=<subnet>]
Table 5.12: Server PPP Command Parameters
Parameter | Description | |
|
| |
DISABLEENABLE | Disables or enables the PPP server. | |
|
| |
LOCALIP=<local_ip> | IP address to be used to connect the CCM appliance over the PPP connection. Must | |
be on same subnet as REMOTEIP address. | ||
| ||
|
|