Bags and Gloves E-9220T Installing or replacing a fixed or removable-mediadrive, To install a drive in an external drive bay:

Follow the instructions in “Preventing static electricity discharge” on page 29. Follow the instructions in “Opening the server case” on page 30.

Installing drives

■IDE drives can be configured as master, slave, or cable-select.

■If cable-select is available (drive assignments will be marked on the cable), the IDE cable assigns the master/slave positions to the drives it connects. You can override these assignments using the jumpers on the drives.

■If cable-select is not available and only one drive is attached to an IDE controller cable, configure the drive as master if it is a CD or DVD drive. If two drives of any type are attached to the cable, configure one as master and one as slave.

■You may need to configure the drives you install using the BIOS Setup utility. Press F2 at startup to open the BIOS Setup utility.

Installing or replacing a fixed or removable-media drive

Use these instructions to install or replace a diskette, CD, DVD, hard drive, or tape drive.

To install a drive in an external drive bay:

1

2

3 If you are replacing a CD, DVD, or diskette drive, go to Step 6, otherwise follow the instructions in “Removing the bezel assembly” on page 32.

4 If you are adding a new drive to an available drive bay, remove the EMI shield from the bay by pulling the assembly out of the bay.

EMI shield

www.gateway.com 39