Gas Rotisserie Oven | Operation |
|
|
Item # Description
1HEAT ON LED
2TIME/TEMP Display
3Program LEDs
4Function Buttons
5POWER ON/OFF Switch
6HEAT ON/OFF Switch
7LIGHTS ON/OFF Switch
8ROTOR ON/OFF Switch
9LOWER FLAME ON/OFF Switch
10PUSH TO RESET Switch
11WATER FILL Switch
12ROTOR JOG Switch
13Drain Lever
Function
Illuminates to indicate that the top burners are on. It cuts off only when the temperature is reached.
Shows time/temperature and other messages during operation. Illuminates to represent the program selected.
ITEM SELECT - This button is used to select the program. When this button is pressed, the controller advances to the next program and its associated LED illuminates.
START/STOP - This button is used to start and stop a cook or hold cycle.
UP AND DOWN ARROWS - These buttons are used for setting time/temperature by incrementing or decrementing to the desired value. These buttons are used in conjunction with the COOK TEMP,
COOK TIME, HOLD TEMP, and HOLD TIME buttons.
COOK TEMP - This button is used to review and/or change the cook temperature for the individual program.
COOK TIME - This button is used to review and/or change the cook time for the individual program.
HOLD TEMP - This button is used to review and/or change the hold temperature for the individual program.
HOLD TIME - This button is used to review and/or change the hold time for the individual program.
REVIEW – This button is used to review and/or change a setting for any program.
Controls power to the entire unit.
Controls ignition of top burners if ROTOR and POWER switch are on and doors are shut.
Controls power to the lights inside oven.
Controls power to the motor that turns the rotors if the POWER switch is on.
Controls ignition of lower burner if the doors are closed and the ROTOR is on. This burner does not cycle on and off as does the top burner.
Pressing this switch resets power to the rotor motor when the motor experiences an overload condition.
Controls the flow of water into the bottom of the unit. Press and hold this switch to cause water to flow. Fill the pan to approximately ¼” (6.3 mm.) of water to assist cleaning of unit.
Controls power to the motor that turns the rotors when the doors are open, the ROTOR switch is on and the POWER switch is on. Press and hold this switch to cause the rotors to turn.
Controls the drain valve inside the unit. To open the valve, place the lever in the vertical position. To close the valve, place the lever in the horizontal position.
9