Gas Rotisserie Oven | Operation |
Probe (Thermocouple) Diagnostics
If the probe (thermocouple inside the oven) stops working, the controller will cancel the cooking cycle, an audible alert will sound, and the display will show “PROB”.
Operation After Gas or Power Outage
The oven will shut off automatically if the gas supply is interrupted or the power goes out. If either of these conditions occur you should perform the following procedure:
For your safety, if the gas supply stops, or, if the power goes out, make sure to wait for at least five minutes before restarting your oven. This allows time for any unburned gas to dissipate. (LP gas may take longer than five minutes.) If you smell gas, do not start your oven.
1.Place the POWER switch, HEAT switch, LOWER FLAME switch, LIGHTS switch, and ROTOR switch located on the front panel in the “OFF” position.
2.Wait at least five minutes to allow any gas that may have accumulated in the burner compartment to escape.
3.Follow normal operating procedures once the power or gas is restored.
Normal Shutoff
1.Place the HEAT switch, LOWER FLAME switch, and LIGHTS switch in the “OFF” position.
2.Wait at least five minutes to allow oven to cool.
3.Place the POWER switch and ROTOR switch in the “OFF” position.
13
