4. Getting started
Image4-1
1Function keys userprogrammable keys w ith functions for directaccess.
2MENU Menu key,to enter or exit the Toolbar menu.
3Address key (recessedkey), to enter the address of the projector (between 0 and 9). Pressthe recessed
addresskey with a pencil, followed by pressing one digit button between 0 and 9.
4LOGO key allowsto recall the stored Logo (not in PiP mode)
5PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6STBY standbybutton, to start projector when the power switch is switched on and to switch off the
projectorwithout switch ingo ffthe power sw itch.
Attention: Switchingto Standby. When the projector is running and you want to
goto s tandby,press the standby key for 2 secon ds.
7MUTE not used
8AUTOIMAGE Autoimage, to center the image on theactiveLCDsurface.
9Digitbuttons direct input selection.
9b SOURCEbutto n thisbutton allows to s witch through the active (scanned) inputs
10 Lenscontrol usethese buttons to obtainthe desired ZOOM, SHIFT, FOCUS.
11 VOL not used
12 Picturecontrols usethese buttons to obtain the desire d pictureanalog level.
22 R5976455 BARCO ULTRA REALITY 7000 30062003