Barco SJ/T 11363-2006 manual `~ÄäÉ=~åÇ=Ç~éíÉê=fåÑçêã~íáçå, MçïÉê=`çêÇ=~åÇ=iáåÉ=sçäí~ÖÉ=pÉäÉÅíáçå

3. Installation

Cable and Adapter Information

•Rack mount each PDS chassis from the front rack ears using four rack screws (not supplied). Rack threads may be metric or otherwise — depending upon the rack type.

•Install the lower of the two mounting holes first.

`~ÄäÉ=~åÇ=^Ç~éíÉê=fåÑçêã~íáçå

The table below provides information regarding cables used with the PDS. When connecting to an PDS, use high-quality shielded cables.

Table 3-1.PDS System Cables

	Cable	Description	Note
		Remote Connections
RJ-45	Ethernet Cable	For use with PDS Web Interface	Customer Supplied
		LED Display Connections
RJ-45	Ethernet Cable, cat5 or	For connection to your LED display.	Customer Supplied
better
		Power Connections
AC Power Cord		AC Power, 7 foot, 10A	1 Cord Supplied

mçïÉê=`çêÇ=~åÇ=iáåÉ=sçäí~ÖÉ=pÉäÉÅíáçå

The PDS is rated to operate with the following specifications:

Input Power: 100-240 VAC, 50-60 Hz

Power Consumption: 100 Watts maximum

The PDS performs line voltage selection automatically. No user controls are required. The AC power cords must be accessible so that they can be removed during field servicing.

Warning When the PDS is used in the 230-volt mode, a UL listed line cord rated for 250 volts at 15 amps must be used and must conform to IEC-227 and IEC-245 standards. This cord will be fitted with a tandem prong-type plug.

The rear panel ON/OFF switch does not disconnect the unit from input AC power. To facilitate disconnection of AC power, the power cord must be connected to an accessible outlet near the unit.

Building Branch Circuit Protection:

For 115 V use 20 A. For 230 V use 8 A.

PDS • User’s Guide 19