![](/images/new-backgrounds/1168258/16825873x1.webp)
3. Installation
Signal Installation
páÖå~ä=fåëí~ää~íáçå
The figure below illustrates a sample PDS system. Use this figure for reference during the signal installation process.
Sample Source IInputt
Devices
* Preview output not available on PDS 701 or 901 * Preview
Inputs 1 - 4 | (Analog) | |
Inputs 5 - 8 | (DVI) ** |
|
Input SDI |
|
|
** Inputs 7 and 8 not available on PDS 701
Ethernet Serial
Program
DVI
Program
Analog
Figure 3-1. PDS System Diagram (sample)
Use the following steps to install signals to/from the PDS:
1.Input connections — any combination of inputs can be connected.
a.As required, connect analog RGBHV sources to Inputs 1 through 4. Refer to the “Format Connection Table” section on page 22 for a table of analog input combinations.
b.As required, connect DVI sources to Inputs 5 through 8 (using the connector’s digital pins). Inputs 7 and 8 are not available on
c.As required, connect analog sources to Inputs 5 through 8 (using the connector’s analog pins). A
d.As required, connect an
2.Output connections — up to three outputs can be connected:
a.If you are connecting the PDS to a digital projector (for example) or other target device, connect the DVI Output to the projector’s DVI input.
b.If you are connecting the PDS to an analog projector (for example) or other target device, connect the Analog
c.If you are connecting the PDS 902 to a Preview monitor, connect the Preview DVI or Analog
PDS • User’s Guide |
| 21 |
|