Barco SJ/T 11363-2006 manual PÉêá~ä=pÉíìé, Remote Control, Unit ID 192.168.000.002 Status Connect

4. Operation

Setup Menu

•Remote Control — This function sets up the PDS for remote control.

REMOTE CONTROL
> Unit ID		25
IP	192.168.000.002
Status		n/a
Connect		OFF

Figure 4-44.Remote Control Submenu (sample)

For complete details, see “Appendix B” on page 129.

•IP — The IP line is an information-only line that shows the current IP address in all modes (with DHCP on or off). If an IP address has not been established (no DHCP server found, or the network cable is not connected), the address reads "000.000.000.000."

Note

The PDS’s default IP address is 192.168.0.10

•M — The M line is an information-only line that shows the MAC (hardware) address of the unit's Ethernet port.

pÉêá~ä=pÉíìé

From the System Menu, select Serial Setup to display the Serial Setup Menu, which enables you to set system RS-232 parameters for the serial port.

SERIAL SETUP
> Baud	115200
Parameters	N81
Handshaking	ON
Reset

Figure 4-45.Serial Setup Menu (sample)

The following functions are available:

•Baud — Use this function to set the baud rate.

~

~

Adjustment range: 9600, 38400, 57600 and 115200

Default: 115200

•Parameters — This function is a combined setting of Parity, Data Bits and Stop bits (in this order).

~

~

Adjustment range: N81, E71, O71, E72, O72

Default: N81

•Handshaking — This is a status field for the hardware flow of the serial port.

~Default: OFF (the only valid value)

By default, RTS/CTS and DSR/DTR are ignored.

•Reset — Use this function to reset all serial values to their default settings.

68 PDS • User’s Guide