Voice Storage and Configuration with the Telset |
Pauses between words may cause the recording to terminate.
If the message is acceptable, press UU to advance to the next voice.
If it is not, keep using 2UU and repeat the message until it is satisfactory, then press UU to accept the current recording. The next prompt you will hear is:
Cv2: “Group One is Electrical”
Again, use 2UU to record the name of the group, and UU to advance. The Cv2 will automatically advance through all six groups, then return to the “Enter Program Code” prompt.
If you don’t need to go through all the groups, press #UU at any time to go back to the main menu (“Enter Program Code” prompt).
2UU - Record or Play Back Points Voices
Cv2: “Point One is Power Failure”
As with the Site and Group IDs (Program Code 1), press 2UU to record a new voice message, UU to advance to the next voice, or #UU to exit to the main menu.
Unless you exit, the Cv2 will automatically advance through all the enabled points, then back to the main menu.
3UU - Group Enable/Disable
Cv2: “Electrical ON” or “Electrical OFF.”
Press 1UU to enable the group, 0UU to disable the group, UU to advance to the next group, or #UU to exit.
Unless you exit, the Cv2 automatically advances through all six groups, then returns to the main menu.
4UU - Query Number Assignment Module (NAM)
Cv2: “Code Four is One” or “Code Four is Two.”
The cell phone in the Cv2 can be programmed to use one of two telephone numbers. Program Code 4 allows you to interrogate the unit as to which number assignment is currently being used. After speaking this message, the Cv2 returns to the main menu.
5UU - Query Mobile Identification Number (MIN - phone number)
Cv2: “Code Five is One Two Three Four ...”
The Cv2 speaks the mobile number as a series of digits, then returns to the main menu.
6UU - Query Electronic Serial Number (ESN)
Cv2: “Code Six is One Two Three Four ...”
The Cv2 speaks the ESN as a series of digits, then returns to the main menu.
B1272M001 | BARNETT ENGINEERING LTD. | ProTalk Cv2 |
