One or two AC power strips may be required to accommodate the quantity of switches in the stack.
3.Apply power to the AC power strip.
Set the AC power strip On/Off switch to On (or connect the AC power strip to a grounded AC power outlet).
4.Proceed to “ Verifying the Installation” following this section.
Verifying the Installation
When installation is complete and power is applied to the stack configuration, check to see that the following LED indications are displayed on the switch LED display panels for all units configured in the stack (Figure 11):
•The Pwr LED and Status LED for all units in the stack are all on (green).
If the Pwr or Status LED for any unit in the stack is off, or blinking, refer to the troubleshooting chapter in the Using the BayStack 450 10/100/1000 Series Switch guide.
•The Cas Up/Dwn LEDs for all units in the stack are all on (green).
If the Cas Up/Dwn LED for any unit in the stack is off, or yellow, check the cable connections to and from the
24
