4.Connect a cascade cable from the Cascade A Out connector of unit 4 to the Cascade A In connector of unit 5.
5.Connect a cascade cable from the Cascade A Out connector of unit 5 to the Cascade A In connector of unit 6.
6.Reconnect the cascade
7.Renumber the order of the units for the new stack configuration (if desired).
You can renumber the unit numbers as described in “Setting Up the Stack Configuration” in the Using the BayStack 450 10/100/1000 Series Switch guide.
Removing/Replacing Units from the Stack
This section describes how to remove and/or replace units in an operating stack.
Because the Redundant Cascade Stacking feature allows signals to loopback at a single point of failure, adjacent contiguous cabled units can be removed and replaced as a single unit from the stack.
For more information about the Redundant Cascade Stacking feature see “ Redundant Cascade Stacking Feature” on page 14.
32
