Bel Canto Design PReProTM General Operation of Unit, Power up unit, Turn unit on and off, Modes

General Operation of Unit

Power up unit

1.Press MASTER power button all the way in. This turns on the power and puts the unit in standby. Do not turn the unit off by pressing this button. Press the OFF button on the right of the font panel.

Turn unit on and off

1.Press any INPUT button on the front panel or on the remote. It will select the input and turn the unit on.

2.To turn the unit off press the OFF button on the front panel or the POWER button on the remote.

Mute the unit

1.Press the MUTE button on the front panel or press the MUTE button on the remote. When the system is in mute the unit will not respond to any commands except the mute command.

2.To un-mute press the MUTE button again on the front panel or the remote.

Volume control

1.Press volume up or down on the remote or front panel.

Modes

1.MUSIC 7. Press this button and the system will go into MUSIC 7 from a PCM source with no flag or analog input. It has no effect with a multi-channel digital input.

2.STEREO mode works by pressing the stereo button on the remote. When you press the stereo button it will take you out of any multi channel processing and put you into stereo mode. If it is a DOLBY Digital input it will mix down to DOLBY 2 channel.

3.SURROUND button. When you have an analog stereo 2 Ch. or PCM Input and you press the surround button, it will put the PRePro in the surround mode.

4.MODE button. This button selects between Dolby Prologic logic2: Music, Dolby Prologic logic2: Movie, DTS Neo6: Music, or DTS Neo6: Cinema as the default for 2-Channel Sources with no flags.

5.7.1 input. When you press 7.1 from front panel or remote the unit will select the DVD video input and the 7.1 audio input.

6.To put 7.1 audio in the full range mode (no filters) press MENU and press 9 to toggle full range YES or NO press SELECT when YES or NO is blinking.

Tuner

1.To select a station on the tuner press SEEK UP or DOWN until you have the desired station. Then press the desired preset button 1 through 10 round button on the remote or front panel and hold down until the sound comes back. Release the button and your preset is set.

2.After you have set all your favorite sta- tions use the preset buttons to select sta- tions.

3.The tuner should use a 75 ohm antenna for FM, and an AM antenna.

Note: The seek is set very sensitive so you can get weak stations, but there will be noise on weak stations.

Main Zone Triggers

1.The PRePro has 2 main zone triggers. One is 12-Volt 200 mA and the other is a dry contact relay at 1 Amp. The relay delay is 5 seconds before the main zone is turned on. When main zone is turned off, 12 Volts is off and the relay opens.

Infra Red Input

1.IR input allows a repeater or blaster input from Zone 2 or any other IR input.

Replacing the AC Power Fuse

1.Turn the unit off.

2.Disconnect the AC power cord.

3.Slide open the fuse drawer completely.

4.Replace with 250V 1 Amp Slo-blo fuse.

© 2002/2003 bel canto design, Ltd. Page 22 PRePro User’s Guide rev1103