Remote Control Learning Mode
This remote control allows you to transfer a command from a button on your source remote control (original equipment remote control) to a button on the Stargate remote control. New commands can be taught to any button in the CD, DVD, AUX, SAT, TV, VCR and CBL device modes, except on the LIGHT button.
The remote control provides distinct visual feedback with LEDs (Light Emitting Diodes) that are located at the top left of the remote control (Status LED) and under the Device buttons. The Status LED at the top left of the remote operates in three colors (red, orange and green). The Device buttons have a red color LED behind them. These LEDs will assist you in programming in the learning section of the remote control.
Learning a New Command
Select a Device mode in which you would like to teach the new command. For exam- ple, if you wanted to learn a new command to the PREV CH button in the TV mode on the remote, you would select the TV Device button and use the instructions below to teach the new command to the PREV CH button.
Step 1.
Press the Device button and the SELECT but- ton simultaneously and hold until the orange Status LED and the Device button turn on and remain lit.
Step 2.
On the remote control, press the button that
is to be taught the new command. The orange Status LED will begin to flash contin- uously. The Device LED will turn off.
Step 3.
On the source remote control (original remote control), press and hold the button for the command to be learned until the Status LED on the remote turns green. Release the button on the source remote con- trol.
Step 4.
Press the button on the source remote con- trol, once again to verify that the new com- mand has been learned correctly. The Status LED will flash green twice and then turn to a steady orange color indicating that the pro- gramming was successful. The Device LED will turn on.
Repeat Steps 2 through 4 for any other but- tons to be taught in the Device mode select- ed in Step 1.
Step 5.
Once you have completed learning new commands to the buttons in the selected Device mode you must save the pro- grammed information. Press and hold the Device button and SELECT button simultane- ously and hold until the orange Status LED flashes twice. The Device button will turn off.
Repeat the above for any other Device modes starting from Step 1.
© 2002/2003 bel canto design, Ltd. | Page 27 | PRePro User’s Guide rev1103 |
