Controls and Functions
Remote Control
The supplied remote control can operate up to eight (8) different components and is program- mable via a learning mode. The eight (8) but- tons located on the top 2 rows allow you to select the component you wish to operate. Please refer to the next section “Remote Control Programming” for instructions on how to manu- ally program this remote control.
To operate the PRePro with this remote control you must first pressthe button labeled ‘AVC’ on the top left corner.
POWER: Puts the PRePro into “Standby” mode. This button cannot turn the unit on; you must use one of the input selection but- tons located further down on the remote (i.e. DVD, LD, VCR1, VCR2, etc.).
MUTE: This mutes the unit.
TV: Toggles NTSC
VOL: Volume up.
VOL: Volume down.
CH: Seek up.
CH: Seek down.
GUIDE: Press for status onscreen.
MENU: Press to get onscreen set up menu.
EXIT: Press to exit onscreen menu.
PRE CH: Turns TFT on and off. Curser and SELECT as used in set up.
DVD, LD, VCR1, VCR2, SAT, AUX, CD, TV, TUNER, TAPE, 7.1: Selects source and turns unit on.
SUR: Puts unit in the surround mode to decode any input format.
Mode: Selects Dolby Prologic movie, Dolby Prologic 2 music,. DTS neo 6 cinema, DTS neo6 music.
BASS: Allows you to set bass trim for each source.
STEREO: Sets unit in the stereo mode.
MUSIC 7: Sets unit in the music 7 mode
1 through 10: Tuner presets.
ZONE: Zone 2 shift button. Allows remote to control AUX, TAP, CD, TUNER, VOLUME, SEEK, OFF, MUTE, for Zone 2.
SHIFT: Toggles the tuner between AM/FM when the tuner source is selected.
SHIFT: In normal mode Toggles EX on and off. If there is an EX flag on the DVD, the shift button will have no effect.
© 2002/2003 bel canto design, Ltd. | Page 26 | PRePro User’s Guide rev1103 |
