Belkin user manual Connecting Computers, Setting the PRO2 into Flash Mode, DIP Switch, Firmware

U S I N G YO U R P R O 2

Connecting Computers:

1.Connect a keyboard, monitor, and mouse to the computer you prepared for firmware update. It must run Windows 95, 98, or Me.

2.Connect the power adapter to the PRO2. Be sure that all connected com- puters are powered off at this moment.

3.Connect the custom flash cable (DB25 Male-to-RJ45; included with purchase). Connect one end of DB25 to your computer’s parallel port and the other end of RJ45 to the PRO2 flash upgrade jack.

Setting the PRO2 into Flash Mode:

The PRO2 has four Flash DIP switches:
	DIP Switch				Firmware
1	2	3	4
ON	OFF	OFF	OFF		Main
OFF	ON	OFF	OFF		OSD
ON	ON	OFF	OFF		Keyboard 1
OFF	OFF	ON	OFF		Mouse 1
ON	OFF	ON	OFF	(F1DA116T Only)	Keyboard 2
OFF	ON	ON	OFF	(F1DA116T Only)	Mouse 2

The DIP switch should be set to the specified settings when you are attempting to update a particular firmware. For example, set DIP switch 1 to “ON” to flash update the main firmware of the switch.

Note: F1DA116T requires that you flash update two firmwares for the mouse and keyboard, separately.

1.Once the above steps have been completed, run the Flash software exe- cutable. Make sure that the appropriate Flash DIP switch is set to the “on” position. Only one firmware can be flashed at one time.

2.After the Flash update has been completed unplug the power supply from the PRO2.

3.Set all DIP switches to the Off position.

4.You are now ready to use your PRO2 or continue flashing a different component if necessary.

22