BENDIX BW2212 manual Aiming Adjuster Tool, IR CAMERA/ Display Combination

Parts/kits listed are now obsolete and are no longer serviceable through Bendix.

AIMING ADJUSTER TOOL

The aiming adjuster tool is included with the Bendix ® X Vision ® Night Vision System kit, but cannot be ordered individually. It is the only tool that should be used to install the IR camera onto the aiming adjusters.

IR CAMERA/ DISPLAY COMBINATION

The IR camera and display are serviceable and can be ordered individually. The IR camera/display combination can be purchased as an entire XVision system.

IR Camera (piece no. 5008214, service piece no. 801150) The IR camera must always be mounted externally to the vehicle and attaches to the standoff pivot assembly and aiming adjusters on the IR camera bracket. The IR camera is operational within the range of -40°C to 60°C.

The IR camera has two electrical connections: a 6-pin IR camera connector and a 2-pin window heater connector.

Aiming

Adjuster

Mounting

IR Camera

Window HeaterConnection

Connection

Standoff Pivot Mounting

FIGURE 12 - IR CAMERA

Video Display (piece no. 5010210, service piece no. 801154) – The display is operational within the range of -40°C to 60°C. During power-up, the Bendix® icon will be displayed in the combiner for approximately 45 seconds. The intensity control will need to be adjusted according to light conditions and driver preference. After the initial warm-up, the IR camera’s field of view (FOV) will be displayed in the combiner.

Combiner

Intensity

Control

On/Off	Fold Mirror
Switch		25-pin Connector
	Video In/Out Switch

FIGURE 13 - DISPLAY (SHOWN IN CB STYLE MOUNT (DASHBOARD) POSITION WITH DISPLAY HARNESS)

The orientation of the virtual image on the display will depend on the display mounting style that you have chosen. On the bottom of the display, under a switch cover, there are four dual inline position (DIP) switches which allow you to rotate or invert the image. To access the DIP switches, slide the cover away from the 25-pin connector. Displays arrive from the factory with the DIP switches configured for the CB style dashboard mount. Refer to Table 5 for the DIP switch settings appropriate for your mount.

FIGURE 14 - DISPLAY DIP SWITCHES FOR DASHBOARD MOUNT

TABLE 5 - DIP SWITCH POSITIONS

Mounting Position	Video	DIP Switch Positions
	Format	1	2	3	4
Dash Mounted	(NTSC)	N/A	OFF	ON	ON
Overhead Mounted	(NTSC)	N/A	OFF	OFF	OFF

8