BenQ SP890 Utilizing the password function, Setting a password, If you forget the password

Utilizing the password function

For security purposes and to help prevent unauthorized use, the projector includes an option for setting up password security. The password can be set through the On-Screen Display (OSD) menu. Once the password is set and this function is selected, the projector is password-protected. Users who do not know the correct password can not use the projector.

You will be inconvenienced if you activate the password functionality and subsequently forget the password. Print out this manual (if necessary) and write the password you used in this manual, and keep the manual in a safe place for later recall.

Setting a password

Once a password has been set and activated, the projector cannot be used unless the correct password is entered every time the projector is started.

English

1.Press MENU on the projector or MENU/EXIT on the remote control and then press / until the Advanced Setup menu is highlighted.

2.Press to highlight Password and press ENTER. The Password page is displayed.

3.Highlight Password and press / to select On. The Input Password page is displayed.

4.As the picture indicates, the four arrow keys ( , , , ) respectively represent 4 digits (1, 2, 3, 4). According to the password you desire to set, press the arrow keys on the remote control or projector to enter six digits for the password.

If the function is used for the first time, enter the default password (1, 1, 1, 1, 1, 1) of the projector by pressing the arrow key six times. Once the password is set, the OSD menu returns to the Password page.

IMPORTANT: The digits being input will be displayed as asterisks on- screen. Write your selected password down here in this manual in advance or right after the password is entered so that it is available to you should you ever forget it.

Password: __ __ __ __ __ __

5.To leave the OSD menu, press MENU on the projector or MENU/ EXIT on the remote control.

Advanced Setup

Lamp Settings

HDMI Settings
Baud Rate	115200
Test Pattern
High Altitude Mode	Off
Audio Settings
Password	ENTER
Lan Control Settings
Reset All Settings
Expert Mode
Direct Power On	Off
S-Video	EXIT Back

Password

Password	On
Change Password
	EXIT Back

Input Password

EXIT Clear

If you forget the password

If the password function is activated, you will be asked to enter the six-digit password every time you turn on the projector. If you enter the wrong password, the password error message is displayed lasting for three seconds, and the Input Password page follows. You can retry by entering another six-digit password, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure. See "Entering the password recall procedure" on page 24 for details.

If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time.

Using the projector 23