TYPICAL OPERATIONS AND HELPFUL HINTS
If the workpiece causes your hand to be in the hazard zone within 6” of the saw blade, clamp the workpiece in place before making the cut.
Cuttinghead must return quickly to the full up position. Sluggish or incomplete return of the cuttinghead will effect lower guard operation possibly resulting in personal injury.
1.Before cutting, make certain that the cutting arm and table are at the correct settings and firmly locked in place.
2.Place the workpiece on the table and hold or clamp it firmly against the fence (Fig. 28).
3.For best results, cut at a slow, even cutting rate.
4.Never attempt freehand cutting (wood that is not held firmly against the fence and table).
AUXILIARY WOOD FENCE
Multiple or repetitive
To limit the possibility of personal injury or blade guard damage, mount an auxiliary wood fence on your saw. Keep the cutting head down until the blade stops whether or not you use an auxiliary wood fence.
Holes are provided in the fence to attach an auxiliary fence (A) Fig. 29. This auxiliary fence is constructed of straight wood approximately 1/2" thick by 3" high by 20" long.
NOTE: The auxiliary fence (A) is used ONLY with the saw blade in the 0° bevel position (90° to the table). When bevel cutting (blade tilted), remove the auxiliary fence.
A
Fig. 28
A
Fig. 29
A
GENERAL CUTTING OPERATIONS
1.Your machine has the capacity to cut standard 2 x 4’s lying flat or on edge, at the 45° right and left miter angles (Fig. 30A).
2.A standard 2 x 6 can be cut in the 90° straight
3.Cutting a standard 4 x 4 can be accomplished with one pass (Fig. 30D).
4.This machine has the capacity to accurately cut crown moldings and other
5.Cutting various sizes of plastic pipe is an easy job with this machine (Fig. 30F). Material must be CLAMPED OR HELD FIRMLY TO THE FENCE TO KEEP IT FROM ROLLING. This is extremely important when making angle cuts.
Fig. 30A
Fig. 30B
16
