Black Box SWI082, SWI081AE manual Boot/On/Off Commands, User Status screen

DUAL-PORT NETWORK POWER SWITCH

When the user mode is active, the /S command will produce the screen shown in Figure 5-2. It lists the status and parameters only for the plug(s) owned by the user password entered at login. If a separate user password has been assigned to the other plug, the User Mode Status screen will not list the status for that plug. In user mode, plug passwords cannot be displayed.

Dual-Port Network Power Switch v1.00 Site: BLACK BOX CORPORATION

Plug	Name	Status	Boot Delay	Password	Default
2	ROUTER_B	OFF	15 Sec	(defined)	ON
Modem Init. String:		ATE0M0Q1&C1&D2S0=1
Modem Disc. String:		+++ATZ
Communication Settings:		9600,N,8,1
Command Echo:		OFF
Disconnect Timeout:		30 Min
Command Confirmation:		ON
Automated Mode:		OFF
Button Mode:		ON

“/H” for Help

Figure 5-2. User Status screen.

5.3 Boot/On/Off Commands

These commands are used to boot or toggle the on/off status of the Dual-Port Network Power Switch’s two switched plugs. If the same password has been applied to both switched plugs, commands can be directed to plug 1, plug 2, or both switched plugs. If a separate user password has been assigned to each plug, then commands can only be applied to the plug that is owned by the user password that was entered at login. Plugs may be specified by name or number.

NOTES

When user mode is active, commands will only be applied to plugs owned by the user’s password. Commands will not affect a plug owned by another user password.

When system mode is active, commands can be applied to both switched plugs.

Wait for the “TPS>” prompt to appear before entering commands. The prompt will not reappear until the previous command is complete.

Commands are not case sensitive. All commands are invoked by pressing [Enter].

30