7.Disconnect Timeout: Determines how long the Dual-Port Network Power Switch will wait for additional commands. Type 7, press [Enter], and follow the instructions in the submenu. (Default determined by option switch 4; Factory setting = 2 Min)
8.Command Confirmation: When enabled, the
9.Automated Mode: When enabled, the
NOTE
When this option is enabled,
10.Button Mode: Enables/disables the manual plug control buttons on the Dual- Port Network Power Switch front panel. When enabled, the Switch’s two switched plugs can be toggled on and off by pressing and holding the manual control button for approximately one second. When disabled, the manual control buttons will have no effect. (Default = On.)
A.Default Parameters: Resets the
NOTE
If the Default Parameters function is invoked via the network port, the IP address is not reset. If this function is invoked via the console port or modem port, the IP address will be reset.
After defining the general parameters, press [Esc] to exit from the General Parameters menu.
22