D9210B
Installation
To activate the D9210B, follow the instructions in the D9210B Program Entry Guide (P/N:32207). Use the ACCESS Program Record Sheet to match the door to the proper address and to ensure that the door is assigned to the proper area.
3.2.13 Step 13: Testing the D9210B
Description. The D9210B comes shipped with a default program that will let you run a quick test upon installing the unit. Go through the following items to verify the D9210B is functioning properly. If you have problems, see Table 9: LED Troubleshooting Guide, p. 25.
D9210B: Verify that the Operational Monitor LED is pulsing approximately once every second. This indicates the microprocessor is running. Go to the Unlock Door function. A number from 1 to 8 should appear for the door controller. If an F appears, the unit has failed or is not responding correctly to the panel’s polls.
Zone: Using the Control Center, verify the point is normal when the door is closed, the point goes off normal when the door is opened and a shunt is not applied, and that the point stays normal upon opening the door on a valid access granted.
Strike: Read a valid token to activate the strike. If tokens have not been added, use the Door Control, Door Unlock mode to cycle the strike. In addition, you will cycle the strike when you test the [RTE/REX] inputs (if shunt only is not programmed [YES].
RTE/REX: Fault these inputs to activate the strike. The default for the strike time is 10 seconds. Test each separately.
Buzzer: The buzzer should have sounded on each strike activation. Also hold the door open past the normal shunt time and ensure the Extend Buzz functions.
Reader: Depending on the reader, the reader LED will be red upon powering up the D9210B. During the above tests, it will turn green anytime the strike is activated.
To verify the reader, check and see that the D1 and D0 LED’s blink rapidly while a card is passed through the reader or a token is held up to the proximity reader.
For other LED functionality, see Table 9: LED Troubleshooting Guide, p. 25.
D9210B Operation and Installation Guide
© 2002 Bosch Security Systems | Page 21 | 32206G |
