Perform Acceptance Testing

For acceptance testing, you must perform administration on both the MERLIN LEGEND system and the Intuity system. Then, you make test calls to check functionality. The major difference between acceptance testing and cut-to- service is the smaller number of subscribers and the more limited functionality tested.

NOTE:

These procedures correspond to the following steps in Chapter 2 of the appropriate Intuity MAP/n Installation Checklist.

Add Test Subscribers 1 and 2

Test Call Answer and Voice Mail

Remove Test Subscribers 1 and 3

You must perform the following tasks to administer a MERLIN LEGEND switch for acceptance tests:

1.Select two subscribers from among the stations listed on Form 2a as having Intuity AUDIX call coverage and defined by Forms 4b, 4d, 5a, or 5b. If you are working during business hours, request that the MERLIN LEGEND System Administrator select the subscribers so that business will not be disturbed.

Use the MERLIN LEGEND system programming procedure described in Chapter 5, ‘‘MERLIN LEGEND Switch Administration’’ in this book to add the extensions of the selected subscribers to the coverage group. The coverage group was defined on the Group Coverage form (Form 7c for Release 3.0; Form 6d for Release 2.0) that you filled out following the instructions in Chapter 2, ‘‘Planning the Integration’’ in this book.

2.Select the same two subscribers from among those defined on the Intuity system using Worksheet Intuity AUDIX Subscriber Administration that you filled out in Chapter 2 of Intuity New System Planning for Release 3.0.

Add the selected subscribers to the Intuity system. Use the Intuity system add subscriber procedure described in Chapter 10, “INTUITY AUDIX Cut- to-Service Procedures” of Intuity Software Installation for Release 3.0.

3.Connect the coverage group to the integrated VMI calling group by using the programming procedure described in Chapter 5, ‘‘MERLIN LEGEND Switch Administration’’ in this book. The calling group was defined on the Group Calling form (Form 7d for Release 3.0; Form 6e for Release 2.0) that you filled out following the instructions in Chapter 2, ‘‘Planning the Integration’’ in this book.

4.Make test calls to each subscriber, but do not answer the calls. The Intuity system should provide call answer service for these calls.

Issue 2.0 December 1995 3-5

Page 59
Image 59
AT&T 585-310-231 manual Perform Acceptance Testing