3.Enter the Routing Table using the information on Worksheet B that you filled out following the instructions in Chapter 2, ‘‘Planning the Integration’’. The Intuity system programming procedure is described in the ‘‘Entering the Routing Table’’ section of Chapter 6, ‘‘Intuity System Administration’’ in this book.
Administer MERLIN LEGEND System for Cut-to-Service
At this time, the Intuity system is ready to process calls. The final administration steps on the MERLIN LEGEND system route those calls through the voice ports to the Intuity system. Perform the following steps to
1.Use the MERLIN LEGEND system programming procedure described in Chapter 5, ‘‘MERLIN LEGEND Switch Administration’’ in this book to add the extensions of the remaining subscribers to the coverage group. The coverage group was defined on the Group Coverage form (Form 7c for Release 3.0; Form 6d for Release 2.0) that you filled out following the instructions in Chapter 2, ‘‘Planning the Integration’’ in this book.
NOTE:
The coverage group was connected to the integrated VMI calling group as part of the acceptance test procedure.
2.Use the MERLIN LEGEND system programming procedure described in Chapter 5, ‘‘MERLIN LEGEND witchS Administration’’ in this book to direct incoming calls on specified trunks to the calling group(s). The calling group was defined on the Group Calling form (Form 7d for Release 3.0; Form 6e for Release 2.0) that you filled out following the instructions in Chapter 2, ‘‘Planning the Integration’’ in this book.
The integration is now complete with the exception of networking.
